since i can get a permit next year i wanted to get a motorcycle. ive always been amazed my motorcycle. but i dont know how to ride one.. and im not intrested in fast motorcycles, just the look will be nice so any suggestions?

Regular maintenance of motorcycles in action
Motorcycle application of the process to its increasingly technical in good condition and the assembly of the (component warranty) has a good performance, must be zero, to change parts and technical state of the law situation Dingqi Zuoye maintenance. Regular maintenance can be in one, split two, three-level maintenance.

1, a maintenance

If the vehicle a certain distance (typically 1000-2000 km Time) should be the provisions of parts lubrication, and tightening the car are screws, nuts. This type of lubrication, tightening the center is called a maintenance and repair. In addition to routine maintenance of the contents of a maintenance project, we have the following elements:

Motorcycle drive chain, should the chain be removed for cleaning, remove belt drive motorcycle, the pulley should be cleaned.

Clean carburetor, air filter, change fuel.

Remove spark plugs on the coke, review and adjust, and distance between the electrodes.

Check all cable connections are easily accessible.

Inspection, adjustment bypass the clutch, throttle handle, brake handle and pedal free travel, and the oil filling control lines.

Speedometer and tachometer on the flexible shaft with grease lubricated.

Oil change.

Second, two maintenance

To check and adjust the middle of the maintenance work is as a secondary supply. Motor Racing General should continue to be 3000-6000 km 2. In addition to a secondary content maintenance projects, maintenance work should be completed as follows:

Clear cylinder, cylinder head, pistons, piston rings and silencer on the coke.

to wear, check the clutch and brake shoes on the brake, depending on the situation of wear can be adjusted or replaced.

Check and adjust gap opener.

Check the before and after the wheels of the runout and concentricity of compliance requirements, such as excessive jumping, to be adjusted or replaced.

If you adjust the valve clearance.

Adjust the seat correctly adjusted damper position.

Inspect the motor, starter, commutator and carbon exchange between the end of the film.

3 3 Maintenance

Decomposition of the Assembly to remove the motorcycle to the inspection, you hidden dangers of the maintenance work for the center of three maintenance. Maintenance typically 6ዀ-10000 km 3 is to verify it’s best for the special maintenance station.

Disassembly of the engine, remove the check the cylinder head, piston, piston rings, exhaust, etc. The coke, the piston and cylinder wall, connecting rod small end bearing and piston pin, crank pin bearing and the majority of the space between the check crank left beating the right half of the amount, so.

Decomposition of the clutch, check the clutch spring free length and friction plate thickness, if necessary, replace the spring or friction plate.

Check the gearbox with or without cracks, erosion, flaking and wear heavy step.

The decomposition of the direction of the column combination, cleaning the direction of the bearing column, add enough fat, converted after the adjustment gap.

Decomposition before the shock, check the front shock absorber spring free length of the compliance requirements, and replacement of the front shock absorber oil.

Check wear the generator, starter motor brush and commutator, if necessary, be replaced.